Screw the plastic tubing connector onto the water fill tube. Using pliers, tighten it securely, but don’t over tighten. The rest of the tubing should be unrolled and left hanging towards the floor.
Now install the two water hose clamps on the back of the refrigerator. Space the clamps out, pull the stickers off of the back of them, and stick them to the refrigerator. The tubing should extend down to the bottom of the refrigerator.
Now push the tubing into the water valve water inlet opening (as shown) and pull back on it to be sure it is attached securely. slide-in fitting will secure the tubing itself.